change user /install

change user /install

Postby stephen » Mon Jun 05, 2006 6:57 pm

Installing MDAC on Terminal Server
may fail as the software should be installed when the server is in install mode,

RESOLUTION
To work around this problem, follow these steps: 1. Set Terminal Server in Install Mode by entering the following command at a command prompt:
change user /install
2. Launch MDAC setup from the command prompt.
3. After MDAC installation succeeds, you can execute the following command to return Terminal Server to the default setting:
change user /execute
stephen
 
Posts: 507
Joined: Thu Feb 09, 2006 9:37 am
Location: Brisbane

Return to AGCO Dealer Software

Who is online

Users browsing this forum: No registered users and 1 guest

cron